Tech

This tech is really, really simple, but as everything else in life, we just try to make things easier on ourselves and this will solve a big pain in the ass. Yes, I'm talking about the clips that hold the pipe flanges. I'm sure the devil had a pretty good agenda when he decided to […]

I've learned a lot about building handmade exhaust systems for the last couple of months. I flat screwed up the first tech on tools, but returned to Home Depot, found the correct parts and went back to work. I picked up a couple of 4-inch C-clamps, and the proper diameter goofball plumbing clamp. I'm still

The stock tranny linkage cut to work as our brake linkage. A week ago I worked on the brake controls with some success. After fabricating a mastercylinder bracket and actually drilling the holes in the proper location, it wouldn’t work. I needed to turn the master cylinder upside down. I called Frank Kaisler to confirm

This is Big Boar's custom battery of choice. It's capable of providing 350 Cold Cranking Amps in a relatively small package. The coolest bikes have always been the stripped down. Whether stock or custom, the less crap the better. So long as the engines weren't too big, or you were running a kick-starter, you could

You made up your mind. It wasn’t easy, but you’re ready to pull the trigger and write a check to get a new bike this week. You’ve done a ton of research and soul-searching to decide on exactly what kind of motorcycle you want to buy. First you thought you wanted to buy a Harley,

Routing the oil lines from the oil tank to the engine is simple task. There are only three oil lines needed to make your bike run: the feed from the oil tank to the oil pump which is located on the engine, the return line from the engine to the oil tank, and the breather

Helluva weekend. Anytime there's lots of motorcycle carnage,sex, whiskey and writing, I'm all for it. Maybe it's Valentines Daycreeping up. Make a note. Here's the deal on the Sturgis Shovelhead. Sincethe engine was in and mounted I went to work on the exhaust system,then seat mounting, position and played with the bars. I made a

Here's an update on the Shovelhead. I picked up the engine from Phil's Speed Shop in Anaheim. He rebuilt the battered heads and lifter stools, installed new JIMS lifters, S&S roller rockers and CCI Black Diamond Valves. He welded and repaired cracks and exhaust manifold threads. Old used Shovelheads can be fragile. I installed studs

The oiling system on overhead valve (OHV) big twin engines from 1936 through 1999 depends on an externally mounted, gear driven oil pump. The oil pump is located in the same spot on the rear, vertical face of the right-hand engine crankcase and as long as it is given a diet of clean motor oil,

A few installments back, I felt like I had run the gamut of topics for these Tech-Tips. I hit the bottom of the barrel with my highly informative, How to Tie a Doo- Rag tip, and figured the powers that be over at the mega-conglomerate motorcycle publishing empire in San Pedro would just cut me