Tech

Hey, here’s quick bit on George The Wild Brush who handled the Pin Striping on the 2005 Sturgis Shovel project. He’s pin striped several other bikes for me in his 47 years behind the brush. Born in Hanford, California, a miserable military town, in 1944, he kicked tumbleweed while his mom worked on a base. […]

Box of parts after teardown for powder. I’m not sure if I’m keeping everything in line. But this segment took us to Foremost Powder Coating in Gardena California. I was at that point when these shots were taken. I’ve had a Powder Coating Sponsor for years, Custom Powder Coating in Dallas. They’re good people and

This isn’t a difficult one but it takes slow time and effort. I handled this in two phases. First I cut the bars and drilled them, even taped the holes. Then I sent the bar to powder. Finally the assembly occurred and I got drunk. There’s something about an internal throttle assembly that’s bothersome. It’s

This is strange. I’m writing several Sturgis Chop Techs after I returned from Sturgis. I’ll try to remedy that in the future, but we were so damn busy trying to complete the bike and run Bikernet, we didn’t keep up on the techs. Many apologies.This piece covers the installation of the hot Speedster cap from

The first thing that pops into my head is Dave Mann’s “Ghost Cowboy” and then Berry Wardlaw dressed as a cowboy. What does that have to do with an article about the hottest engine to hit the motorcycle industry this year? Well hang on and you’ll see. Berry Wardlaw, of Accurate Engineering in Dothan Alabama,

This is one of Bob Le Pera's original Banana seats from the early '70s. He still makes them today. If you check out the spec sheets for custom bikes in about any mag, and you come upon the seat section, chances are you’ll find Le Pera listed as the manufacturer. Motorcycle seat = Le Pera,

Click to see morefrom Lucky Devil The old pipe to oil tank tab.My first move began with a correction. I removed the exhaust pipe tab welded to the oil bag. The oilcan is rubber mounted, the exhaust pipe generated severe heat and the pipe system needs to be solidly mounted. It had to go. Actually

Brembo has a solid worldwide reputation, and I ran into a hot looking Brembo representative at an illustrious bike function and decide I’d give them a try. They’re hot and ready to rock. The only items I needed were the locking nuts for the back of the rotors bolts and the springer axle spacer. This

Here we go. I’m relunctantly behind the eight ball, or more likely the 5-Ball in this case. The bike is nearly complete and I haven't caught up with the articles. For the most part I was working at Primedia on the bike mags and didn’t have time to breath. No fucking lame excuses. Let’s hit

Having the right tool makes all the difference. No matter what job you plan, the first question is do I have the knowledge and experience to handle it myself, or even with the help of friends? The second, do I have the tools? If the answer is yes, you are good to go. Some people