Though my 2022 Harley Ultra Limited is a very comfortable motorcycle, past experience has taught me that being able to change my position from time to time is definitely important.
I have used this same set up for over 100,000 miles and it was an easy decision to put them on this motorcycle.
https://www.harley-davidson.com/us/en/shop/long-angled-adjustable-highway-peg-mount-kit/p/50500167
Description:
Stretch out for added comfort. This Adjustable Highway Peg Mounting Kit can be set for shorter riders, and it can be reversed to reach far forward for those with long legs.
• 5-inch angled peg mounting kit in gloss black finish
• Angled design allows the arm to reach back and around to clear fairing lowers
• Arm can be raised and lowered for a custom fit
• Mounting clamp firmly grips the engine guard, and the locking design secures the peg at the desired angle
There are two versions of the Angled Highway Peg Mounting. A short and a long version. I am using the long version.
They are available in Black which I am using and Chrome.
There are numerous styles of foot pegs that can be used with this set up and they can be found on Harley’s web site.
https://www.harley-davidson.com/us/en/shop/kahuna-footpegs/p/50501225
Understated but powerful, the Kahuna Collection’s rich gloss black surface is surrounded by deeply grooved, rich black rubber that provides grip and traction where needed.
• Gloss Black finish.
Installation:
If you work on your own motorcycle and have some basic tools this should be an easy install.
Tools:
3/8 Drive Ratchet
3/8 Drive 5/16 Allen Socket
3/8 Drive 1/4 Allen Socket
You will also need Blue Thread-locker (243)
Position the Mounting Clamp Halves around the engine guard. The head pin should be upward. The cogged face of the clamp should face the extension arm.
During The Following Steps I Suggest Tightening Parts Tight Enough So That They Do Not Move But Can Be Adjusted Before Final Torque.
Position the arm so that when footpeg is installed it will not interfere with the foot controls or hit the ground when cornering.
Sit on upright motorcycle and test position of assembly. Adjust as necessary.
Repeat procedure on opposite side of motorcycle.
Measure both arms are the same height from the ground and pegs rotated to a comfortable position. Put Blue Thread-locker on footpeg bolt and Torque to 21 Foot Pounds
Install the setscrew into the lower of the two holes on the back side of the arm and adjust until the angle of the footpeg is comfortable for you.
Torque assembly to 55-60 Foot Pounds.
